We narrowed to 918 results for: IRE

...recheck the pH to prevent over or undershooting the desired pH. Allow the solution to mix for 10 min and then...proceed overnight at 4 °C if needed. Transfer the entire sample to 3 x 500 mL conical bottles and centrifuge...

...plasmid DNA, the plasmid will already be in your desired bacterial strain and you will not need to obtain...

...wear glasses/goggles in addition to the BSL-1 requirements. Conclusion Although simple, following appropriate...

... in LB medium. The concentration of antibiotic required for effective over-agar selection has been empirically...

...balance and then tare it. Then add the material directly to the tube to weigh it. Make sure that your scoopula...

...linearize a plasmid to determine the size of the entire construct or excise some or all of an insert from...

...The annealed but nicked vector product is then repaired during the replication cycle. Empty vectors for...

...the cells in the remaining well, a cell count is required for calculating the titer. Incubate for 48–72 ...

...and yield. If there are significant amounts of undesired product, gel-purify DNA segments. Otherwise, PCR...

... ∼500 ng of DNA, while molecular cloning often requires 1 µg of DNA. The total reaction volume usually...

...recheck the pH to prevent over or undershooting the desired pH. Allow the solution to mix for 10 min and then...

... μl of a 1:5 or 1:10 dilution rather than 1 μl directly....

...recheck the pH to prevent over or undershooting the desired pH. Allow the solution to mix for 10 min and then...

... positively charged and will run the opposite direction from the DNA. So if you run the gel without EtBr...

...antibiotic in culture, or remove the antibiotic entirely. If the antibiotic is reduced or removed from ...

...Figure 2 Using the box tool, draw a box around the entire first gel lane (as in Figure 2). Select Analyze...

...which should be on the same focal plane. Scan the entire plate and make note of each well in which you see...

...droplets are not disrupted, insert the pipette tips directly in the center of the well and tilt to a 45° angle...